Strands / wires within a screwable line bushing   

                                                  
Line bushings are used to electrically connect equipment in potentially explosive atmospheres. The connection is always established either between a flameproof enclosure and an enclosure of another type of protection in accordance with DIN EN 60079-0. Alternatively, two flameproof enclosures are connected. Thus cables are protected from direct contact

Varying with the design, line bushings can be used in intrinsically safe, measuring, control or energy circuits
By the definition of the threads on adaption to a standard enclosure is very easy.




Standardized the threads are  M10 bis M42, variation on this must be approved by a notified body in the case of Ex application.

   

Here you can find 'standard'-line bushings in our webshop

Very often the screwable  line bushings are used to connect the  'increased safety' enclosure with a 'flameproof d-' enclosure 
By this there is a direct connection between increased safety enclosure and flameproof d enclosure.


This is an overview for your orientation. If you need more wires within a special diameter, please contact us, we will prove it at the line bushing itself

Our line bushings got an 'X' approval und therefore these line bushing are useable
everywhere(without additional approval work); also as replacement for existing line bushings



                                       Flexibilty of the solution for your application
 

Cable within a screwable line bushing

The use of screwable  line bushingswith unilateral cable is often used with a flameproof encapsulated enclosure, where the increased safety enclosure is separated from the d-enclosures. This is frequently used in measuring devices, transducers and data lines.


Our line bushings got an 'X' approval und therefore these line bushing are useable
everywhere(without additional approval work); also as replacement for existing line bushings






                           Our Kow How for your efficency!