Strands
Line
bushings are used to electrically connect equipment in potentially
explosive atmospheres. The connection is always established either
between a flameproof enclosure and an enclosure of another type of
protection in accordance with DIN EN 60079-0. Alternatively, two
flameproof enclosures are connected. Thus cables are protected from
direct contact
Varying with the design, line bushings can be used in intrinsically
safe, measuring, control or energy circuits
By the plugability you need a locking ring and
a screw up protection
Standardized the diameter is 10mm up
to 40mm variation on this must be approved by a
notified
body in the case of Ex application.
You
should prefer plugable line bushings, if there is a preassembled
conector or something else mounted at the strands.
The strands will be connected to terminal in the increased safety
enclosure
This
is an overview for your orientation. If you need more wires within
a special diameter, please contact us,
we will prove it at the line bushing itself
Our
line bushings got an 'X' approval und therefore these line bushing
are useable
everywhere(without additional approval work); also
as replacement for existing line bushings
The right type in accordance to your application
Cable
The use of screwable line bushingswith unilateral cable is
often
used
with a flameproof encapsulated enclosure, where the increased safety
enclosure is separated from the d-enclosures, but not the possibilty of
rotating the strands. This leads to an easy installation with a great
amount of strands in the flameproof enclosure.
By the
plugability you need a locking ring and
a screw up protection
Our line bushings got an
'X' approval und therefore these line bushing are useable
everywhere(without
additional approval work); also as replacement for existing line
bushings
Easy mounting for your
benfit!